Wednesday, April 30, 2014

Mother Day Shaped Tea Pot Card

Dimensions are 6.00 by 5.00

Used free card front tea pot file from www.birdscards.com

Made my own card shape file

Used pink card stock to go behind rose cut out

Green card stock used to make leafs show up

Pink card stock used to make separation between lid and pot

Embossed tea pot

Stamped on top of lid thinking of you in black ink

Liquid pearls in flower centers and on top of Pearl

Glitter

Friday, April 25, 2014

How to do Pull-Tab Slider Card

Pull-Tab Slider Card

by Julie Masse

Pull a sliding tab to animate your card and reveal a message.

Supplies

Cardstock
Ink
Stamps – a focal image and sentiment stamp(s) (TCP Besties clear set used here)
Slot and circle dies, or ruler and craft knife (TCP CutUps Slider die set used here)
Adhesive (Glue Dots and foam dimensionals used here)
Other stamps, dies and embellishments as needed to complete the project

Step-by-Step

Step 1
To prepare the sliding panel, cut cardstock to 3.25" x 5". Die cut a pull tab from cardstock, then fold the piece in half and adhere the open side to the edge of the panel. Stamp a sentiment on the panel if desired.

Note:
To create a pull tab with a small circle die, fold a small piece of cardstock in half. Position the die so one side slightly overlaps the fold. Cut as usual.
Step 2
Cut a slider slot in the card front. The slot for the sample is approximately 1/4" wide by 3.75" long. The cut can be horizontal or vertical.

Hint:
If using a die, use a bit of low-tack tape to hold it in place for cutting. If you don't have a die, cut the slot with a craft knife.
Step 3
Die cut another tab from cardstock. Run a line of adhesive up the center, and fold the tab in half to align the circles. Fold across, then turn the sides back to form an “I” shape.
Step 4
Stamp, color, and cut out the focal image of the card. Adhere one side of the tab to the back of the image using a glue dot.

Note:
Be sure that the center of the slider tab is oriented to the direction in which the image should slide.
Fold the other side of the tab in to insert it through the slot. Lay the tabs flat.
Step 5
Align the slider and sentiment panels, and adhere the back of the slider tab to the sentiment panel.
You will now be able to slide the image back and forth using the pull tab.
Step 6
Add foam dimensional adhesive to the back of the card front around 3 sides of the sentiment panel, leaving the end with the tab free of adhesive.
Step 7
Adhere the panels to the card base. Embellish as desired to complete the card.